Re: Help with WCCP setup

Dunae:
Here is the output fron netstat -i and ifconfig -a

[root@proxy0 squid]# netstat -i
Kernel Interface table
Iface MTU Met RX-OK RX-ERR RX-DRP RX-OVR TX-OK TX-ERR TX-DRP TX-OVR Flg
eth0 1500 0 561556 0 0 0 83991 2 0 0 BRU
gre0 1476 0 134 0 0 0 0 0 0 0 ORU
lo 3924 0 46012 0 0 0 46012 0 0 0 LRU

[root@proxy0 squid]# ifconfig -a
gre0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-14-00-00-00-00-00-00-00-00
          UP RUNNING NOARP MTU:1476 Metric:1
          RX packets:134 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0

Daniel E Visbal

----- Original Message -----
From: Duane Wessels <wessels@ircache.net>
To: Daniel E Visbal <daniel.visbal@sta.sistecol.com>
Cc: <squid-dev@ircache.net>
Sent: Sunday, September 26, 1999 10:59 PM
Subject: Re: Help with WCCP setup

On Sun, 26 Sep 1999, Daniel E Visbal wrote:

> I'm writing this mail to squid-dev but I'm not part of squid-dev.
> Since WCCP is on develop stage, and no questions are allowed at squid-users, and that
you have redirected all question about WCCP to squid-dev...
>
> I'm running Squid on Intel Linux and on Alpha Digital Tru64 Unix.
> I will like to enable WCCP on both system.
> Linux kernel is 2.2.9-27mdk
> Digital Unix 4.0F or it can be upgraded to 5.0
>
> Router Cisco 4700
> IOS (tm) 4500 Software (C4500-I-M), Version 12.0(6), RELEASE SOFTWARE (fc1)
> IP WCCP ENABLE
>
> On Linux all I know is that I should install GRE and have gre0 up.
> But I do not know how to redirect it to squid or if the gre0 interface should have an
IP?.
> What I have done is:

Does 'gre0' show up in your 'netstat -i' output?

I'm just curious to see the counter values.

Duane W.
Received on Mon Sep 27 1999 - 00:45:51 MDT