Randy Smith wrote:
> I didn't. I was happily running STABLE4 without problems. I upgraded to
> STABLE6 and this started showing up. AFAIK, I didn't build it any
> differently this time and I definitly didn't change my config file.
>
> So, what turns turns this off and where is the documentaion that mentions
> squid.alloc?
squid.alloc is enabled by the configure directive
--enable-xmalloc-debug-trace, which should absolutely not be used in
production.
See config.status for a list of the configure options you used when building
Squid (in Squid-2.5 and later this information will also be printed by "squid
-v", but this is not the case for Squid-2.4 or earlier)
Regards
Henrik
Received on Thu May 02 2002 - 08:33:16 MDT
This archive was generated by hypermail pre-2.1.9 : Tue Dec 09 2003 - 17:07:52 MST